YBT250 NetTek Field Transmitter and Interference Tester v1.415

Major Changes For This Release
------------------------------

· Measurements for the EDGE signal standard.

· Enhancements to the existing GSM signal standard.

· Various other improvements to existing functionality.


More details for the YBT250 can be found at
Mobile Communications > Wireless Field Test on the Tektronix Home Page.


Installation
------------

1) Unpack the ZIP file downloaded from the web.

2) The archive file YBT250Y_upgrade_v1-415b.arq (from the downloaded ZIP file) is for upgrading the YBT250 while it is installed on a Y350C NetTek Analyzer platform. Copy this file to a PC memory card.  NOTE: Do not attempt to use this archive file for performing an upgrade of a YBT250 while it is installed on a Y400 NetTek Analyzer platform.

3) Install the PC memory card into the NetTek. 

4) Start up the NetTek. 

5) On the NetTek, select Start > Programs > Tektronix Utilities > Module Upgrade and follow the on-screen instructions on the NetTek. 

6) When the module upgrade is complete, tap Restart Now on the NetTek to complete the installation. 

7) The YBT250 is now ready to use. To start the application double-click the YBT250 icon on the NetTek desktop, or select Start > Programs > NetTek > YBT250.
 
8) After you start the application, the NetTek Analyzer Platform will copy the YBT250 software from the module into the platform and perform the installation. This process takes several minutes, but enables future power-ups to occur faster. 

9) Once the application is installed, it will launch. Verify that the version number for the software on the splash screen matches the version on the YBT250 CD-ROM. 


NOTES
-----

· Even though the YBT250 upgrade was performed using the Y350C NetTek Analyzer platform, once the upgrade process has successfully completed the YBT250 can be used on either the Y350C or Y400 NetTek Analyzer platforms.

· The installation utility is all that differs between the YBT250Y_upgrade_v1-415b.arq file and the previous YBT250Y_upgrade_v1-415.arq release. The installation utility has been corrected to address SW installation failures that were observed for some YBT250 application modules. The resulting SW that is installed on the application module is the same 1.415 SW release.